- #Ucpool maxsea time zero how to
- #Ucpool maxsea time zero serial number
- #Ucpool maxsea time zero update
Turn the RotoKey Clockwise to select the System menu page. Once the MFDBB is powered, press the RotoKey to acknowledge the agreement then press the key. To set the Master MFDBB as a slave (without performing a Master Reset), power ON the Master MFDBB. If the subject MFDBB is configured as the Master (DHCP ENABLED ), it needs to be set as a slave before updating the software (proceed to the next step if the MFDBB is not the Master or if you have already performed a Master Reset). Leave the Ethernet cable for the Keyboard connected. Power OFF every MFD in the network and disconnect the network cable of every MFD (this can be done by disconnected the Ethernet cable on the back of the MFD or at the HUB). Do NOT mix Navnet 3D MFD Software Revisions in a given network. If entered via Ucpool file, they will not be erased. *Unlock codes entered manually will be erased.
#Ucpool maxsea time zero how to
Please refer to the appendix for detailed instructions on how to perform a Master Reset. Performing a Master reset will automatically set the MFDBB as a slave and clear all settings (a Master Reset will not remove any chart data*). You must perform a Master reset on the MFDBB before applying this update. Before updating an MFDBB system that is configured as a Master (DHCP ENABLED or ON ), it must be reconfigured as a Slave (DHCP DISABLED or OFF ) from the Installation Wizard section of the menu. To correctly apply the update, all MFD(s) MUST be disconnected from the Network. Please refer to the appendix for detailed instructions on how to backup waypoints and route data.
#Ucpool maxsea time zero update
Furuno STRONGLY RECOMMENDS that critical waypoints/routes are saved to a separate SD Card before you attempt to update an MFD s Software. You may also supply your own 2GB or 4GB Jump Drive (DUX mother board requires 4GB USB Jump Drive) and download the update (approximately 800MB download) from Please refer to the appendix for detailed instructions on how to download the necessary files and create a USB Jump Drive that can be used to update an MFDBB. Dealers can view service advisory #06-12T dated April 30 th 2012 for more information.
#Ucpool maxsea time zero serial number
MFDBB processor units sold before March 1 st 2012 and having a serial number of and lower use a Kontron motherboard and must use USB Jump Drive part # NN3-KON-JMP. Part # for a preprogramed USB Jump Drive is NN3-DUX-JMP. New MFDBB processor units sold after March 1 st 2012 and having a serial number of and higher use the DUX motherboard. Caution: You must use the correct software file depending on what type of Motherboard is in the MFDBB. A pre-programmed USB Jump Drive can be purchased from FUSA.
Additionally, a USB KEYBOARD and USB MOUSE ARE REQUIRED to perform the update. NN3D v2.13 Update Introduction MFDBB The combo update for the MFDBB requires a USB Jump Drive (USB flash memory stick). 1 How to Update NN3D to v2.13 (Combo Update) MFDBB 1.
0 kommentar(er)
